1259352 caterpillar:switch SWITCH AS-PRESSURE

Hydraulic Pressure Switch 125-9352 162-0782 for Cat E320D E325D – Dual OE(125-9352)
Generic Direct replacement mechanical pressure switch compatible with Caterpillar OE 125-9352 (hydraulic) and 162-0782 (transmission) — triggers warning lights when system pressure drops below safe operating levels. || This non-electronic ON/OFF switch uses a diaphragm and micro-contact design to activate dashboard alarms on Cat E320D, E325D, and E330D excavators — contains no circuit board, ECU link, or emission control function. || Pre-calibrated to factory pressure thresholds (typically 20–30 bar) and features rugged brass housing with 2-pin AMP connector for reliable performance in high-vibration hydraulic systems. || Installs directly into the main hydraulic manifold or transmission housing — no programming, calibration, or software update required after installation. || ⚠️ Aftermarket safety component for off-road construction machinery only. This is a basic mechanical alarm trigger, not a precision sensor, and must not be used in on-road vehicles, agricultural sprayers, irrigation systems, or any EPA/FIFRA-regulated equipment.

Hydraulic Pressure Switch125-9352 162-0782 for E320D E325D(125-9352)
clould fitness Sensors || This non-electronic switch uses a diaphragm and micro-contact design to activate dashboard alarms on E320D, E325D, and E330D excavators — contains no circuit board, link, or emission control function.

Hydraulic Pressure Switch 125-9352 162-0782 for Cat E320D E325D – Dual OE(162-0782)
Generic Direct replacement mechanical pressure switch compatible with Caterpillar OE 125-9352 (hydraulic) and 162-0782 (transmission) — triggers warning lights when system pressure drops below safe operating levels. || This non-electronic ON/OFF switch uses a diaphragm and micro-contact design to activate dashboard alarms on Cat E320D, E325D, and E330D excavators — contains no circuit board, ECU link, or emission control function. || Pre-calibrated to factory pressure thresholds (typically 20–30 bar) and features rugged brass housing with 2-pin AMP connector for reliable performance in high-vibration hydraulic systems. || Installs directly into the main hydraulic manifold or transmission housing — no programming, calibration, or software update required after installation. || ⚠️ Aftermarket safety component for off-road construction machinery only. This is a basic mechanical alarm trigger, not a precision sensor, and must not be used in on-road vehicles, agricultural sprayers, irrigation systems, or any EPA/FIFRA-regulated equipment.